View source for KB 181

===Configuring the Actiontec 1520 (the white model) for a WAN static or
public subnet.===
 Article:181
 Created:2002-11-20 13:10:09
 Categories:
   DSL

====Question or Symptom====
How do I configure my Actiontec 1520 (the white model) Wireless-Ready
DSL Gateway to use a static WAN IP or public subnet?


====Resolution====
=====Static WAN IP=====
-------------
  
There is no difference in the configuration of the Actiontec for a dynamic or
static WAN IP.  The assigning of the static IP takes place upon login.
Configure using the SWCP Knowledge Base article 175, 
Configuring the Actiontec Wireless-Ready DSL Gateway (ethernet and NAT).
  

=====Public Subnet=====
-------------
  
If you have a public subnet (2 or more public IP's), there are a few differences.
  
First, complete the instructions in the SWCP Knowledge Base article 175,
Configuring the Actiontec Wireless-Ready DSL Gateway (ethernet and NAT).
  
Next, open your web browser of choice, and surf to http://192.168.0.1.  This 
will take you to the web interface for configuring the router.  Click 
"Setup/Configuration." 
  
There will be sidebar on the left.  Click "Advanced Setup."
  
Click the "Begin Advanced Setup" button.
  
Again,in the left-hand sidebar, click "LAN IP Address."
  
Enter the first IP from your public subnet.
  
Click "Next" through the next several screens unti you reach the one with the
heading "NAT."  
  
Click the "Off" radio button.
  
Click "Next" until you reach the screen with the heading "Save and Restart."
  
Click the button "Save and Restart."
  
You are done.

====Related KB articles====
  [[KB 175]] Configuring the Actiontec 1520 (the white model) to use NAT